I created this bur block to hold my 4 Paste tubes and matching rag wheels. You really don’t want to mix them up.

Download contains 2 files: Solid and Hollow. The Solid object is printable on any printer. But, it will consume a lot of resin on an SLA printer. FDM printers will allow you to adjust the infill. It does not need much strength to do it’s job.

The Hollow one is designed for SLA/Resin printing. It SHOULD print predictably. But, due to the small hole diameter, you need to clean them out thoroughly after printing. Honestly, I think it’s not worth the trouble. Just print solid and eat the cost if you want to use it. Or, find someone with an FDM printer.

Amazon Affiliate Links:
3000grit: https://amzn.to/3VSOas2
8000grit: https://amzn.to/3Eux9N1
14,000grit: https://amzn.to/3uols6p
50,000grit: https://amzn.to/3L13AVR

Ragwheel (2.35mm): https://amzn.to/3uWFJBa